Parts for other equipment

Software for editing cutting data and cut paths (start point, direction, sequence, notch, angle, piece move and other adjustments.

Reduces loss of pressure, noise, prevents increase of power consumption after cutting operation.

Allows to transfer elastic materials without tension directly to Jema cutting machines, avoiding incorrect cutting length. This set contains also a device for laying down and passing over tangled tape without using a feeder — it can be passed straight from the box. Maximum tape width - 100 mm

Knife set for automatic tape cutting devices. Upper knife width 105 mm. Original spare part for Jema JM-120LR, JM-110LR devices.

Filtering system for laser devices with a working surface of 1600x1000mm. Used for air filtration in laser cutting and engraving, laser marking, laser welding, soldering and printing. The system capacity is 1500m3 / h Specification: power: 1.2 kW Power supply: 110 / 220V Pressure - 3500Pa / 0.04Bar 4 separate layers of filters 99.7% filtration Equipped with a remote control LCD panel displaying pressure and air flow and a warning system about the required filter replacement. A key to close the c

Toothed belt for automatic tape cutting machines Jema JM-110LR . Spare part for 2nd and 3 rd generation cutting machines. 1st generation - cutting width 65mm, with temperature controller 2nd generation - cutting width 95 mm, with a temperature controller, produced by the end of 2019 3rd generation - 95mm cutting width, without a temperature controller, produced from 2020 until now

Upper silicone roller for JEMA brand automatic cutting machines . Spare part for the JM-120 series tape cutting machines.

Oiler for TEXI ZORRO 110 FREE

Lower roller for automatic cutting device Jema JM-120LR

Stepping motor for automatic hot and cold cutting device - JEMA JM-120LR.

Width 50 mm, thickness 1 mm.